==== Driver Configuration for NEC Mxx1, MExx1 Series Displays (External Control over LAN) ====

You can monitor and control your NEC displays (External Control via LAN) connected to your network.

The following display models are supported : 
  - NEC Mxx1 Series
  - NEC MExx1 Series

Let's start by configuring your display :

  - Check the IP address of your NEC display (e.g., 192.168.0.1): [HOME] Settings / Network / Ethernet / IP Address
  - Verify that you can connect to the display's administration interface: http://192.168.0.1


Next, let's configure the driver :

  * **IP** : the IP address of the display
  * **Port** : TCP port used by External Control (default is 7142)
  * **Monitor ID**: configured Monitor ID (default is 1)

Your display is now added as a device in Zebrix Control.