==== Driver setup for Yealink RoomBar AXX ====

You can monitor and control your Yealink RoomBar AXX series devices, via RoomConnect, connected to your network.

Let's start by configuring your device:

  * Verify the IP address of your Yealink RoomBar (e.g., 192.168.0.1) and check the connection to the administration console accessible at [[https://192.168.0.1/]]

{{:fr:guide:yealink:roomconnect:meetingbar:pasted:20250310-161834.png}}

  * Once authenticated, you will see the following screen: Please note the IP address used for device management (highlighted in red on the screen below). Then go to System > Device Manage > 3rd DM Service and enable **HTTPS API** and enter a password for the API in **HTTPS Authentication Password**. Finally, click **Confirm**.

{{:fr:guide:yealink:roomconnect:meetingbar:pasted:20250310-162242.png}}


Next, let's configure the driver in the Zebrix Control administration interface:

  * **URL** : The URL of the Yealink RoomBar, like following pattern %%https://ip%% (for example : %%https://192.168.0.1%%).
  * **Username** : The account used to log in to the device (default: admin).
  * **Password** : The password used to log in to the device. Enter the password you configured when enabling the **HTTPS API**.
  * **Allow self-signed certificate** : Check this box if the device's SSL certificate is self-signed.

Your videoconferencing device is now added as a device in Zebrix Control.

Contact Zebrix support for more information.